So I noticed this bug in a play through I had going with 2 different robot facilities in one settlement. Whenever I refreshed a plot it would get stuck on whatever building stage the robot was on and wouldn't ever finish. After a lot of looking around I figured out I could fix the issue by using the Immersion Breaker Breaker but I figured I'd toss in this report here in case anyone else had this issue.
Also as a small side note the second floor of the General Atomics building is just a BIT too low in my game and prevents me from entering or leaving the building without using tcl.
Edit : So after loading my save before all the testing and hitting it with the immersion breaker the problem stayed, so I'm not sure of a reliable way to fix this.
Edit 2 : Alright so, until a better fix is found it looks like to fix it you have to refresh the plot, and then have a new robot spawn before the old one respawns, using set timescale to 800 will do the trick after a few attempts.
Also as a small side note the second floor of the General Atomics building is just a BIT too low in my game and prevents me from entering or leaving the building without using tcl.
Edit : So after loading my save before all the testing and hitting it with the immersion breaker the problem stayed, so I'm not sure of a reliable way to fix this.
Edit 2 : Alright so, until a better fix is found it looks like to fix it you have to refresh the plot, and then have a new robot spawn before the old one respawns, using set timescale to 800 will do the trick after a few attempts.
Last edited:
