Solved Circuitry lab left computer panels floting?

[CodeNamed1]

So I managed to upgrade to circuitry lab and got the quest of it but I was not happy with the place I settled it so I destroyed it now there are these floating computer panels where the building was and I can’t get rid of them also I still have the quest: Computer Recearch Assistant at stage “check back later to see how research progress is going”?, any help?


Another problem has occurred with the military salvage building, there were these Defective institute beacons and I threw couple of them and they have been sparkling since a very long time in the places I threw them. That building was also destroyed But this one I do not have active quest in my quest log, help?

 

[uituit]

There is a clean up tool in the holotape but I cant remember where.
Try refresh local plots Tools>config Tools.
do you have place everywhere ? u can use that to scrap those bits left over
The sparks , not sure how to get rid of those I get them sometimes from wires and I roll back my save to fix.
I think you would have to complete the quest before it goes away

 

[CodeNamed1]

No they are not those sparks, these are blue ones, left by the institute beacons and there’s this weird box on the ground where the sparks come from.

I’ll try to look for that clean up tool

 

[CodeNamed1]

Can I still complete the quest if I build the building back?

 

[uituit]

you should be able to .

yeah the holotape has so much in it these days and I get lost in there sometimes the clean up tool was made to clean up smoke and stuff like that so if you can find it may help with the sparks as well

 

[CodeNamed1]

Found it, it was in Tools>Clean up settlement
Sadly it did not help in removing neither one

 

[uituit]

o ok
for the panels you can use console commands.
Open console with this key ~ hightlight the object, type disable and then enter if the panel dosnt delete type enable .
just make sure you save before you try that , you don't wanna delete something important

 

[CodeNamed1]

Jeij I was able to remove the panels with Place Everywhere now the sparks, can the console be used to remove those?

 

[uituit]

idk about the sparks
with the console command you have to be able to target the object u want to delete and I don't think sparks have a physical object but you can try

otherwise its something you will have to put up with

 

[CodeNamed1]

Well they don’t bother me that much, as long as they can’t grow Into bigger like performance or stability problems. I could use imagination and make them be something special