Kinggath: "Uncheck Sim Settlmeents and any expansions or addons of it from your load order, also uncheck HUDFramework - because it sometimes interferes with startup. Load your game and make a save outside of the museum. Now check in Sim Settlements again and load that save - the tape should spawn where it belongs. Once you have the tape, load it in your pipboy to get the unlock message. Now save again, and re-enable HUDFramework."
Gotcha!yeah...pressed Enter but it reloads on that menu
i dont get what you are saying...you mean the mods i have installed?Load order might help shed some light on the problem.
in the museum i found nothingread the help page below as it will tell you how to find the plugins.txt, your load order.
Ok, NMM is now at V 0.65.6, v0.65.2 and further updates had issues, but then dont we all. Again link on help page
The dirct method is no different then what I have listed on our help page but when you did it manually, you ticked the box in NMM and moved SS up to the top? or did you use LOOT right after install and then go into NMM and tick the box.
So you found the boxes of sensors but not the holotape, I do think your load order is needed
ss is on the top...i will take a pic of the nmm so u can seeread the help page below as it will tell you how to find the plugins.txt, your load order.
Ok, NMM is now at V 0.65.6, v0.65.2 and further updates had issues, but then dont we all. Again link on help page
The dirct method is no different then what I have listed on our help page but when you did it manually, you ticked the box in NMM and moved SS up to the top? or did you use LOOT right after install and then go into NMM and tick the box.
So you found the boxes of sensors but not the holotape, I do think your load order is needed
ss always comes on top even after disabling and re-enablingIf Sim Settlements is "above" HUDFramework it can cause the holotape Not to load.
lemme tryMove it below HUDFramework.
We use essential cookies to make this site work, and optional cookies to enhance your experience.