- Messages
- 1,018
Here's a curious one.
If I build a plot, everything is fine. The plot will build and will upgrade, nothing out of the ordinary.
Now, if I go to the plot and adjust its position using Place Everywhere - so I go into workshop mode, select the plot, and raise/lower it, or move it left/right then exit workshop mode, and select Refresh Plot from the ASAM Sensor, what used to happen is, the plot would refresh, and build itself again, using the new position it found itself in, having been moved by Place Everywhere.
What I am seeing now is that the plot will refresh itself, but the ASAM Sensor will remain in its original position, so the plot may refresh itself and may move slightly, but the ASAM Sensor stays fast in its original position.
Has anyone else seen this behaviour? I cannot recall this behaviour previously.
If I build a plot, everything is fine. The plot will build and will upgrade, nothing out of the ordinary.
Now, if I go to the plot and adjust its position using Place Everywhere - so I go into workshop mode, select the plot, and raise/lower it, or move it left/right then exit workshop mode, and select Refresh Plot from the ASAM Sensor, what used to happen is, the plot would refresh, and build itself again, using the new position it found itself in, having been moved by Place Everywhere.
What I am seeing now is that the plot will refresh itself, but the ASAM Sensor will remain in its original position, so the plot may refresh itself and may move slightly, but the ASAM Sensor stays fast in its original position.
Has anyone else seen this behaviour? I cannot recall this behaviour previously.